🔩
Is the bit installed and secure?
Make sure the collet is tight and the bit is fully seated with no wobble.
Help💡
📍
Are the 0 coordinates set to the bottom-left corner of your material?
X0 Y0 should be at the front-left corner of your stock. Use the jog controls and "Zero X / Zero Y" if needed.
Help💡
⬆️
Is the bit clear of the material?
The spindle must not be touching or engaged with the material when the job starts. Raise Z so the bit is safely above the surface.
Help💡
📏
Is the material thick enough for this job?
Confirm the stock thickness matches or exceeds the cut depth in your G-code. Cutting through thin material can damage the spoilboard or break the bit.
Help💡
🗜️
Is the material securely clamped down?
Unsecured material can shift during cutting, ruining the job or causing injury. Check all clamps are tight and clear of the toolpath.
Help💡
🚀
All checks passed — ready to cut!
The machine will begin streaming G-code immediately after you press Start.